Singer 1036 Creative Touch Manuel d'utilisateur télécharger pdf (Page 9)

Changing One-Piece Presser Foot

CHANGING PRESSER FEET

Snap-on Presser Feet

Most of the presser feet furnished with your

machine snap on and off a common shank.

1. Raise take-up lever to its highest position

by turning the hand wheel toward you.

2. Raise presser foot.

3. Press toe of presser foot upward (as far as

it will go) and then snap down to remove.

4. Center the new presser foot under the

shank and lower the presser-foot lifter so

that the shank fits over the presser-foot

pin.

5. Press presser-foot screw down until foot

snaps into place.

To remove and replace the shank of snap-on

presser feet, follow instructions below for

one-piece presser feet.

One-Piece Presser Feet

1. Raise needle to its highest position and

raise the presser foot.

2. Loosen presser foot screw and remove the

foot guiding it to the right.

3. Hootc new foot around the presser bar and

tighten presser foot screw.

CHANGING PLATES

(Note: Remove bobbin if it contains thread in

order to prevent thread being caught when

plate is replaced.)

1. Raise take-up lever to its highest position

by turning the hand wheel toward you.

2. Raise presser foot.

3. Open slide plate. Press down on front edge

of plate and lift up and out.

4. Position new plate over pins and release.

Plate is drawn into position by magnets.

5. Close slide plate.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 65 66

Commentaires sur ces manuels

Pas de commentaire