Singer 1036 Creative Touch Manuel d'utilisateur télécharger pdf (Page 49)

FREE’MOTION EMBROIDERY

Monogramming with Plain Zig-Zag Pattern

Free-Motion Embroidery

In free-motion embroidery, you control the

direction and speed of fabric movement by

means of an embroidery hoop. Stitch length is

determined by the speed at which the hoop is

moved and zig-zag stitch width is varied by

the direction of hoop movement. The hoop

should be one designed for machine use.

• Stitch; Plain Zig-Zag ^ (or Straight Stitch [ )

• Stitch Width; 2 through 5 (or Straight Stitch)

• Needle Position;

• Speed; In MIN range

• Feed Cover Plate (See page 4 for attaching)

• No Presser Foot or Shank

1. Attach feed cover plate.

2. Trace or transfer design outline to right

side of fabric and center in embroidery

hoop. Make sure fabric is taut.

3. Raise presser-foot lifter to its high position,

place hoop under needle and lower presser

bar to engage thread tension.

4. Hold needle thread loosely with left hand,

turn hand wheel over, and draw bobbin

thread up through fabric.

5. Lower needle into fabric, hold thread ends

and start stitching. After two or three

stitches, cut thread ends.

6. Run machine at an even rate of speed,

following or filling in design outline as ap

propriate. Move hoop rapidly to increase

stitch length and change the direction of

hoop movement. To shade change zig-zag

stitch width from wide to narrow.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 65 66

Pas de commentaire

Singer 1036 Creative Touch Manuel d'utilisateur Page 49