Singer 2001 TouchTronic Manuel d'utilisateur télécharger pdf (Page 15)

CHANGING NEEDLE PLATES

Remove bobbin if it contains thread in order to

prevent thread being caught when plate is

replaced.

Raise needle and take-up lever to highest

position by turning the hand wheel toward you.

Raise presser foot.

• Open slide plate. Press down on front edge

of needle plate and lift up and out.

• When changing to straight stitch needle

plate, move feed to right-hand position.

Move Feed to Right-Hand Position when Using

Straight Stitch Needie Piate

• When changing from straight stitch needle

plate to any other needle plate, move feed to

left-hand position.

•

• Position new plate over pins and release.

Plate is drawn into position by magnets. See

special instructions on page 10 for attach

ing chainstitch plate.

• Close slide plate.

Machine has been designed with a movable

feed. This allows close contact between feed

and presser foot when straight stitching and

is beneficial in helping to hold fabric in place

while stitching.

Move Feed to Left-Hand Position when Using

Generai Purpose Needle Plate

Caution: The straight stitch foot and zipper

foot must oniy be used with the straight stitch

needle plate. Needle breakage can occur if the

straight stitch foot or zipper foot is used with

any other needle plate.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 125 126

Pas de commentaire

Singer 2001 TouchTronic Manuel d'utilisateur Page 15