Replacing a Wound Bobbin
Raise needle and take-up lever to highest
position by turning hand wheel toward you.
A. Open slide plate; move bobbin latch to
left. Remove used bobbin.
B. Draw about 1 inch (2.5cm) of thread
from bobbin and insert bobbin in case.
Move bobbin latch slightly to the right
(sewing position). Pull thread into bob
bin case Slot 1.
G. Draw thread under flat spring and around
to and past point 2, leaving 3 inches
(7cm) of free thread.
0. Close slide plate to prevent thread
from coming out of threading points
while raising the bobbin thread, as ex
plained on next page.
26
Commentaires sur ces manuels